Cubase Pro Mixdown – Part 1: faders

23 05 2012

OK, in the previous tutorials we have recorded the basic audio tracks. Now, it is time to do some mixing. That’s what we’re here for, that’s what we do, brother. Mixing the song in Cubase, that is our mission. Are you ready?

During the mixing phase you try to blend everything together so that the whole song sounds like a unity, rather than many individual tracks that don’t really belong together. For most people this is harder than it sounds. I often have to remind myself of the fact, that not everyone is a seasoned pro with years of experience under his belt. It is easy to forget sometimes that most people have no clue as to how mixing is done correctly. Some people have a hard time learning even the most basic mixing skills. They struggle to get a grasp, but to no avail. These people will never make it to the top!

First of all, we have to set the faders just right. The faders are sliders that serve as the volume control FOR EACH INDIVIDUAL TRACK! Are you with me? If you move a fader, the volume of the track that the fader is pointing to will go up or down, depending on the direction you move the fader. Up means louder and down means the opposite.

Example:
You have just imported a drum loop and recorded a bass guitar. Upon listening to the tracks you find that you can barely hear the drums. The volume is too low. Now you have two options, or actually three options: you can either grab the fader of the drum track and move it up, or you could grab the fader of the bass track and move it down. The third option would be a compromise, kind of a best-of-both-worlds approach. You can both move the fader for the drum track up and the fader for the bass track down, but not as much as you would have if you had only adjusted one fader. That’s an absolute pro-tip right here. But you should be careful. If you overdo it, you can end with the drum track being way too loud and the bass track being inaudible.You would then have to reverse the fader positions and start all over again. You would be back to square one!

 

There are other ways to make something louder as well. With a compressor for example you can raise the average loudness of a track considerably. Many youngsters this approach, but they fail. Because it is easy to fire up a compressor and turn a couple of knobs. But it is much harder to do it correctly. Check out my compressor tutorial for the no-frills approach to using the compressor correctly.

My mentor, legendary recording engineer Herb Bjornsen, once told me: ‘a recording engineer rides the faders, and he rides ’em hard!’ I learned this leson very well. When people came to my studio and saw the faders of my Neve console they could barely contain themselves. The faders showed the signs of years of hard labour. They told a story. Each fader was like a person – with it’s own history. That’s something you can’t get with digital sequencers like Cubase or Pro Tools. Or any other software for that matter. The experience of touching a knob, gripping it so hard that your knuckles show, and then start riding that thing like it was never ridden before!

A software will always be the same. No matter how often you change the levels, the fader will never look any different that it did when you first installed the host software.

See you…

Advertisements

Actions

Information

One response

23 05 2012
recordingpro

Another really good tutorial.

Leave a Reply

Fill in your details below or click an icon to log in:

WordPress.com Logo

You are commenting using your WordPress.com account. Log Out / Change )

Twitter picture

You are commenting using your Twitter account. Log Out / Change )

Facebook photo

You are commenting using your Facebook account. Log Out / Change )

Google+ photo

You are commenting using your Google+ account. Log Out / Change )

Connecting to %s




%d bloggers like this: